Work can be so easily 640-822

Get Your 640-822 exam Exam Training

In the field of IT competition is increasing day by day and you need to keep update yourself by doing certifications. If you are interested in 640-822 braindumps then you are at right place. Discover the secrets to pass Interconnecting Cisco Networking Devices Part 1 exam and become Cisco certified. Here we provide you complete information to pass Interconnecting Cisco Networking Devices Part 1 test. We will provide you access to the top companies for up to date 640-822 exam test exam preparation material. Check out the mentioned Work can be so easily 640-822 question and answers material we have for 640-822 actual tests.

We have Interconnecting Cisco Networking Devices Part 1 and 640-822 preparation guides. These are the best providers and there is guarantee to pass the Cisco 640-822 exam after praparing from their materials. Buy 640-822 exam questions and answers, 640-822 study guides and 640-822 labs and get certified. You can either use tk 640-822 question answers or p4s question and answers. Both are 100% guaranteed.

640-822 Practice Questions are provided by 640-822 dumps training programs to help the candidates. This does not only provide 640-822 questions and answers but give the opportunity to students to go through the 640-822 exam practice tests as well. These Cisco Security 640-822 training exams provides training tools including Interconnecting Cisco Networking Devices Part 1 practice questions and answers, 640-822 Study Guides etc.

1. Refer to the exhibit. A network technician has added host A to the network. Host A cannot communicate on the network. A ping that is issued on the host to address 127.0.0.1 fails. What is the problem?

A. The router is not forwarding the ping packets to network 127.0.0.0.

B. The remote host at 127.0.0.1 is unreachable.

C. The default gateway is incorrect.

D. The IP address of host A is incorrect.

E. The TCP/IP protocols are not loaded.

Answer: E

2. Refer to the exhibit. A network technician is attempting to use HyperTerminal to configure a new router using the settings shown. What is the reason the technician is unable to connect to the router?

A. The bits per second should be set to 9600.

B. The data bits should be set to 6.

C. Parity should be set to mark.

D. The stop bits should be set to 2.

E. Flow control should be set to hardware.

Answer: A

3. Refer to the exhibit. What could be possible causes for the "Serial0/0 is down" interface status? (Choose two.)

A. A Layer 1 problem exists.

B. The bandwidth is set too low.

C. A protocol mismatch exists.

D. An incorrect cable is being used.

E. There is an incorrect IP address on the Serial 0/0 interface.

Answer: AD

4. Which line from the output of the show ip interface command indicates that there is a Layer 1 problem?

A. Serial0/1 is up, line protocol is up

B. Serial0/1 is up, line protocol is down

C. Serial0/1 is down, line protocol is down

D. Serial0/1 is administratively down, line protocol is down

Answer: C